15
ELECTRIQUEHOW TO CHECK THE SWITCHBOARD OPERATION
N.B.:
If the engines are not equipped with an end-of-stroke device terminals 14-16 15-16 16-17 16-18.
If the STOP button is not connected terminals 11-12 are to be bridged.
If no photocell is present terminals 12-13 are to be bridged.
FUNCTION
DIP 4
DIP 5
DIP 6
DIP 7
A
OFF
OFF
OFF
#
B
OFF
OFF
ON
#
C
OFF
ON
OFF
#
D
OFF
ON
ON
#
E
ON
OFF
OFF
OFF
F
ON
OFF
OFF
ON
G
ON
OFF
ON
OFF
H
ON
OFF
ON
ON
I
ON
ON
ON
OFF
L
ON
ON
ON
ON
M
ON
ON
OFF
#
DIP
DIP CONFIGURATION No 4-5-6-7
1
On provides the pre-blink function for about 3 seconds.
2
Off activates the photocells only when closing. ON will cause the photocells to operate both when closing and opening thus
stopping the movement of the wing.
3
OFF cust off the electrical lock release.
8
ON Set Up.
In normal conditions (if not programmated) the
DIP 8
it does have to be place in OFF position
DIP CONFIGURATION No 1-2-3-8
OPERATION MODES
A
: Step-step OPEN-STOP-CLOSE without automatic re-close function.
B
: Step-step OPEN-STOP-CLOSE whit automatic re-close function.
C
: Step-step OPEN-CLOSE without automatic re-close function.
D
: Step-step OPEN-CLOSE whit automatic re-close function.
E
: Half-automatic, during the opening it will not accept other incoming signals until it has not closed, it has no automatic re-close
function and in case sick function is required the CLOSE button is to be used.
F
: Half-automatic, same function as E, but during the pause even an Open signal causes the gate to close.
G
: Automatic, the radio impulse or single signal have no effect until the pause has expired, a signal during the pause resets the
time.
H
: Automatic, same functions as G, a signal during the pause causes the gate to close.
I
:
Half-automatic, OPEN-STOP-CLOSE after the STOP signal sent with the OPEN button or by the remote control counts the
pausing time and re-close functions - a signal during the pause causes the gate to close.
L
: Half-automatic, same function as I, a signal during the pause causes the gate to close.
M
: “PRESENT MAN” operation (manual).
#
:
No effect in ON or OFF.
ENGLISH
Summary of Contents for CB 8221 L
Page 22: ...22 NOTE ...
Page 23: ...23 NOTE ...
