2 - About your vehicle
69
• Using the wrench
A
with socket
B
turn
the cable inside the fl exible shaft for the
LH fl ap control in a clockwise direction,
while turning the RH one in an anti-
clockwise direction, until the side fl aps
are completely open.
A
B
8
• Working on both sides of the vehicle at
the same time, lift the soft top from its
housing bay and, holding it as illustrated
in the fi gure, tilt it forwards.
When lifting the soft top, do not use the rear
ends of the fi ns as a resting point as this could
damage the kinematic mechanism. Try to
synchronise movements on both sides of the
soft top, as far as possible, in order to avoid
dangerous loads on the kinematic mechanism.
• Remove the cover support and lower it
by pushing it as much as possible into
the closed position.
Using the cross-head screwdriver
C
and
the pin
on the cover joint as a resting
point, pull the fork-shaped end
of the
piston moving the cover on both sides
towards the rear.
C
2
1
• Keep the cover pushed down in the
closed position and lower the engine
compartment lid.
Summary of Contents for F430 SPIDER
