Glue Gun
AFTER SALES SUPPORT
(toll free)
MODEL No.: PGG40G • 05/2020 • 701256
e-mail: info.aldi@positecgroup.com
AUS
9
1300 889 028
AUS
Gluing
1) Press the flow control trigger (5).
2) Apply the glue in dots around the edges of the workpiece
surface. For gluing flexible materials (e.g. textiles), apply the
glue in a zig-zag line.
Danger of burning!
The glue and the nozzle tip are heated to
200 °C. Do not allow the hot glue to come into contact with
persons or animals. If hot glue touches the skin, immediately hold
the spot for several minutes under a stream of cold water. Do not
try to remove the glue from the skin.
3) After applying the glue, press the surfaces to be glued
together immediately for a stronger bond.
4) Press the glued surfaces together for approximately 30
seconds. To assist with adhesion, apply a weighted load or
clamp to the glued junction for approximately 5 minutes.
5) Between individual gluing actions, place the gun on the
support stand / rest (6) .
6) Remove glue residue after cooling with a sharp knife. The
glued junction can be separated again by heating. The glued
junction can be painted.
WARNING: Do not place the heated glue gun on the
support stand or have the nozzle pointed downwards
for a long period of time when using! The glue will
continue to slowly flow from the nozzle!
WARNING: The glue gun should be switched off and
allowed to cool down after 12 hours continuous use.
