11
MODEL No.: PPL9001.A • 02/2022 •
704518
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
900W Planer
2. Dust extraction guide switch (See Fig. B)
You can select the right or left side of the dust
extraction port (4) by turning the dust extraction
guide switch (12) to the left or right.
When viewing the planer as shown in Fig B,
moving the dust extraction guide switch (12) to
the left will cause chips to be discharged to the
right; moving it to the right causes chips to be
discharged the left.
3. Baseplate stand (See Fig. C)
By lifting up the rear of the planer, the baseplate
stand (22) will allow the planer to be set down
directly 10mm from the surface and protect the
cutting blades (20) from any damage and the
blades (20) from damaging the surface. When
planing, the stand (22) will be pushed away by the
end of the wood. Always check the stand (22) is
free to move on the base plate (8).
4. Parallel guide
- Assembling the parallel guide (See Fig. D1-D3)
Place the angle bracket (7d) on the parallel guide body (7a) as shown
in Fig. D1. Align and insert the locking nut (7c) from above of the angle
bracket (7d) through the hole of the angle bracket (7d) and the parallel
guide body (7a), then insert the locking screw (7b) from below the parallel
guide body (7a) into the end of the locking nut (7c). Firmly tighten the
locking screw (7b) by turning it clockwise.
B
C
D1
D2
D3
22