13
MODEL No.: PPL9001.A • 02/2022 •
704518
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
900W Planer
the rebate depth scale on the rebate guide (14) with the triangle symbol
(a). Tighten the rebate guide locking knob (13) by turning it clockwise.
6. Adjusting the cutting depth (See Fig. F1, F2)
The proper cutting depth should be determined
according to the hardness, gumminess or moisture
content of the material being cut, as well as the
feed rate.
Smaller cutting depth of 0-2 mm is best for most
surface planing or rebating. Rotate the cutting
depth adjustment knob (11) to set the required
cutting depth by aligning the number on the
planing depth scale (10) with the triangle symbol
as shown in Fig. F2.
The scale graduation on the cutting depth
adjustment knob is 0.5 mm. The clockwise rotation
increases the planing depth; the anti-clockwise
rotation reduces the planing depth. Always work
from a rough cut to a finish cut.
It is recommended that test cuts be made in scrap
wood after each adjustment to make sure that
desired amount of wood is being removed by your
planer.
NOTE:
To protect blades during storage, transporting, etc., set blade depth
adjustment knob to 0.
Operation
WARNING:
Before using your planer, be sure to read the
instruction manual carefully.
WARNING:
Danger of kickback! Apply the machine to the
workpiece only when switched on.
1. On/off trigger (See Fig. G)
The switch is locked off to prevent accidental starting. To start the planer,
connect the power plug to the mains socket, depress the lock off button
(2) then depress the on/off trigger (3). Then you can release the lock off
F1
F2
