8
2.2
Placement on wall
1.
Mount screws & washers in the brackets towards the wall.
(Screws elements are
not
included the installation kit)
2.3
Installation of SSO:s (1-8)
NOTE!
To calculate correct cable dimensions you can use
Ferroamp
’
s
online
cable
calculator,
available
at
1.
Unscrew the front plate as shown above. The front plate is
attached with a PE-cable to the cabinet.
2.
Connect L-, L+ & PE from each SSO to designated screw
terminal.
3.
Make sure that all terminals are tightened to 2.5 Nm, use a
torque wrench.
Summary of Contents for Power Distribution 8
Page 1: ...Installation manual Swe En Power Distribution 8 Rev A01 Rev B01...
Page 2: ......
Page 12: ...Electricity Reinvented...
