·
4.2. Preparation of the installation
You have to verify on the place that the measures are corrects and fixing points are
accessible. Superior plates, supporting the rolling axis, have to be fixed on a good reinforced
concrete or soldered on a steel support.
You can add more fixing plates if necessary, correctly shared on the total length.
You have to measure the opening dimensions (width and height) and to verify them with
the delivery documents.
The high-speed door has to be assembled by qualified and authorised staff following
assembly instructions manuals.
The area has to be securitised and the circulation has to be completely forbidden.
·
4.3. To assemble
Check there is no obstacle to install the frame and check the are where the door will be
installed is correctly levelled, otherwise you must suitably level it.
·
4.3.1.
To start the assembly, you must
completely unpack lateral guides and superior
protection cover. You only have to remove the
packing corresponding to the necessary parts
(extremities) to fix lateral guides with superior
frame. The rest of packing must to be maintained
to avoid damaging the door during the assembly,
or the blade fall.
Place the upper roll-up drum on the floor and
insert the two lateral guides into the lateral plates
placed on the upper tray. Fix the different parts
using the 6 hexagonal Allen screws of size 8 x 10
and their corresponding washers.
·
4.3.2.
Once lateral guides fixed, you
have to place the motoreductor on the door’s
axis, using the 2 screws of size 10 x 30 and their
corresponding washers.
15
