6. Maintenance
·
6.1. After-Sale Service
For the maintenance, emergency repairing, reparations, please contact your supplier or
the manufacturer.
·
6.2. Control and maintenance
The maintenance and the inspection can only be done by staff prepared and
authorised by the manufacturer.
·
Before to do any previously mentioned repairs, you have to disconnect the power supply
into the electrical control box using the locking switch. Using a tester, you have to verify that
control box is not supplied.
·
The working area has to be closed. Once reparation done, don’t forget to remove materials.
·
Intervals, controls and necessary information for the execution are described and
documented in the inspection plan.
·
6.3. Cleaning
·
Don’t use detergent for the crystal (because of its aggressive components).
·
Do never use abrasives, scrappers, razor-blades, putty-
knife, etc…
· Use heat water with a small quantity of soft cleaning agent for plastic and a
clean duster, flexible and not fluffy.
·
6.3.1. Cleaning and maintenance of the protector blade
Clean with hot water and detergent recommended for plastic surface. Use a clean chamois.
·
6.3.2. Cleaning and maintenance of the door frame
The dust can be removed with a soft duster. Important dirt can be removed with water and
a standard liquid cleaner.
Metallic surfaces can be cleaned with grease or oil mixed with a product with a dissolvent base.
Don’t use high pressure cleaner.
·
6.3.3. Cleaning of surrounding areas
After the maintenance operation mainly, some dirt can have contaminated the ground in
the direct lateral parts’ surrounding. They have to be carefully removed.
31
