ECONCEPT SOLAR ST
6
EN
cod. -- - 11/2010 (Rev. 00)
Indication during operation
Heating
A heating demand (generated by the Room Thermostat or Remote Timer Control) is indicated by flashing of the hot air
above the radiator (details 24 and 25 - fig. 1).
The display (detail 23 - fig. 1) shows the actual heating delivery temperature and, during heating standby time, the mes-
sage
"d2"
.
The heating graduation marks (detail 26 - fig. 1) light up as the heating sensor temperature reaches the set value.
fig. 2
Domestic hot water (DHW)
A hot water tank heating demand is indicated by flashing of the hot water under the tap (details 12 and 13 - fig. 1).
The display (detail 14 - fig. 1) shows the actual hot water outlet temperature and, during DHW standby time, the mes-
sage
"d1"
.
The DHW graduation marks (detail 11 - fig. 1) light up as the hot water tank sensor temperature reaches the set value.
fig. 3
Exclude hot water tank (economy)
Hot water tank temperature maintaining/heating can be excluded by the user. If excluded, domestic hot water will only
be delivered by the solar circuit; the latter is managed by the controller DBM29 whose specifications are given in
cap. 4.7 "DBM29 (ECOTRONIC tech) - Solar Controller".
When hot water tank heating is activated (default setting), the COMFORT symbol (detail 15 - fig. 1) is activated on the
display, and when off, the ECO symbol (detail 15 - fig. 1) is activated on the display.
The hot water tank can be deactivated by the user (ECO mode ) by pressing the
economy/comfort
button (detail 7 -
fig. 1). To activate the COMFORT mode, press the
economy/comfort
button (detail 7 - fig. 1) again.
eco
comfort
m
o
de
r e s e t
eco
bar
eco
comfort
m
o
de
r e s e t
eco
bar
eco
comfort
m
o
de
r e s e t
bar
eco
comfort
m
o
de
r e s e t
comfort
bar
comfort
