1.3 Filament Power Supply Description and Specifications
Section 1: Introduction to the CV-12SLX
CV-12SLX User Manual
0101-8292-0, Rev. C
1-2
HVPS Specifications
Dimensions
8.75 in. H × 19 in. W × 23 in. D
Weight: 93 lbs.
Input Power
208-V Model CV-12SLX, Single- and Dual-Gun Versions
208 V ac +10% /–5%, 50/60 Hz, 50 A
3-phase delta (4-wire)
400-V Model CV-12SLX, Single- and Dual-Gun Versions
400 V ac +10% /–5%, 50/60 Hz, 30 A
3-phase wye (5-wire, with neutral)
NOTE
Current capacities listed above are for the facility breaker supplying power to the HVPS
and include the AC power required for up to two FPS units. Power cable(s) for FPS
unit(s) should always be connected to the HVPS rear panel, not to a separate power
drop.
High Voltage Output
12 kW at 10 kV max.
Fully adjustable 0–10 kV
Regulated to within ±5%
Beam Current
Fully adjustable, 0–1200 mA dc
Regulated to within ±5%
Environmental Requirements
Must be free of corrosive vapors
Ambient temperature: 104° F (40° C) maximum
Humidity: 10%–90%, noncondensing
1.3 Filament Power Supply Description and Specifications
Figure 1-2 shows the filament power supply, a stand-alone assembly that must be installed near
the vacuum chamber.
Figure 1-2 Filament Power Supply Front Panel
