MACHINES AND
ACCESSORIES
Page 18 of 26
7.2 Before using the Bench chamfering machine
For safe operation of the machine it is advisable to perform some checks:
1. check that the power cord does not have any flaws or damage;
2. verify the correct operation of the stop/emergency switch;
3. verify the correct operation of the machine.
7.3 Use of the Bench chamfering machine
Use of the machine
Use the machine for chamfering rough metal edges at 45°.
Use the machine for a maximum chamfer of 5 mm.
1.
Press the green start button (ref. B in Figure 5).
2.
Place the piece to be chamfered on the guide rail and push it towards the milling cutter
without pressing excessively.
Risk of abrasion and accident
Hold the piece at the upper and rear part. DO NOT place fingers under the work piece for any reason!
NEVER grab the work piece with bare hands, it has a high temperature and sharp burrs.
Always wear appropriate personal protective equipment (PPE) such as gloves, to avoid injury.
Thin or small pieces
When working with very thin or small pieces, a special tool must be used to push the piece and hold it in
place on the rail.
3.
When finished, turn off the machine by pressing the red stop button (ref. A in Figure 5).
Risk of abrasion
After pressing the stop switch, the milling cutter continues to rotate by inertia for a few seconds.
Keep body parts away from the moving tool!
When a certain degree of roughness of the chamfer is detected at the end of processing, it is
advisable to carry out more applications. Light chamfering is recommended for thin and
narrow materials.
fervi.com
Summary of Contents for 0560
Page 1: ...USE AND MAINTENANCE MANUAL Bench chamfering machine Art 0560 ORIGINAL INSTRUCTIONS fervi com ...
Page 24: ...MACHINES AND ACCESSORIES Page 24 of 26 11 EXPLODED VIEW AND SPARE PARTS fervi com ...
Page 26: ...MACHINES AND ACCESSORIES Page 26 of 26 12 DIAGRAM OF THE ELECTRICAL CIRCUIT fervi com ...
