3. Installation
3-30
Festo P.BE-MPA-EN en 1108e
3.5
Address assignment of the valves
3.5.1
MPA-S valve terminal with CPX terminal
Maximum 16 MPA pneumatic modules are permitted on
the MPA-S valve terminal with CPX terminal. The following
number of solenoid coils is therefore possible
(if only valves of the same size are used):
– MPA1: up to 128 solenoid coils
(maximum of 64 valve positions)
– MPA2: up to 64 solenoid coils
(maximum of 32 valve positions)
Note
Note with the addressing that an MPA2 pneumatic module
has only 4 addresses compared to an MPA1 pneumatic
module.
Assigning the addresses
–
The assignment of the addresses is module-orientated
–
A pneumatic module always occupies
–
MPA1: 8 addresses
–
MPA2: 4 addresses
–
Counting begins on the valve terminal from left to right
–
Each valve position occupies 2 addresses, irrespective of
the valve or blanking plate fitted.
The following assignment applies:
–
solenoid coil 14 occupies the lower-value address,
–
solenoid coil 12 occupies the higher-value address.
Summary of Contents for 530411
