5. Maintenance and conversion
5-4
Festo P.BE-MPA-EN en 1108e
5.2
Dismantling the MPA-S valve terminal
Providing the MPA-S valve terminal is easily accessible,
it need not be dismantled when the following components are
replaced or removed:
–
Valves or blanking plates
–
Electronics module
–
Exhaust plates or flat plate silencer
Disconnecting the electrical connections
Connecting variants
Procedure
CPX terminal
•
Instructions on dismantling the electrical connections can be found
in the CPX system manual.
Multi-pin plug connection
•
Loosen the mounting screws and remove the Sub-D multi-pin plug.
Tab. 5/1:
Disconnecting the electrical connections
Disconnecting the pneumatic connections
Disconnecting the pneumatic connections is described in
Chapter 3.
Dismantling the MPA-S valve terminal
The procedure for dismantling the MPA-S valve terminal is
described in Chapter 2.
Summary of Contents for 530411
