5. Maintenance and conversion
5-37
Festo P.BE-MPA-EN en 1108e
Mounting
Proceed as follows:
1. Mount the new sub-base and, if necessary, an additional
pneumatic supply plate (see section 5.3.6).
2. Only MPA-S valve terminal with multi-pin plug connection:
If the new sub-base added is the last one in front of the
right-hand MPA end plate, you must insert the type MPA
end piece into the last interlinking board (see Fig. 5/17).
3. Mount the valves or blanking plates onto the empty valve
positions (see section 5.3.3).
4. Mount the MPA-S valve terminal onto its mounting
surface (see Chapter 2 Fitting, “Mounting onto a wall” or
“Mounting onto an H-rail”).
5. Then install the pneumatic and electrical connections
(see Chapter 3 “Installation, connecting the MPA-S valve
terminal”).
Note
If a sub-base is inserted between existing sub-bases, the
address assignment of all valves to the right of the
inserted sub-base will be shifted.
Summary of Contents for 530411
