CESA-GW-AS-PB Description
39
See also <Advanced Diagnostics for AS-i Masters>.
By using "Clear all" and "Set all" all bits in this list can be delete or set, respective-
ly, at the same time. Below this is a list of all slaves that can be selected individu-
ally in order to set or delete the LOS bit.
6.8.9
AUTO ADDR (enable automatic address)
Main menu || SETUP ||
AUTO ADDRESS
||
This function is used to enable or disable automatic address assignment.
This mode can be:
6.8.10
FACTORY RESET (factory default settings)
Main Menu || SETUP || FACTORY RESET ||
This function can be used to reset the master to the factory default settings. The
“Reset” is done by selecting menu point DO RESET.
6.9
IO + PARAM.TEST
Main menu ||
IO + PARAM.TEST
||
The following warning message will be displayed before entering this menu:
Empty field: LOS bit deleted
X: LOS bit set
AUTO ADDRESS
ENABLE
CHANGE
Enable: automatic address assignment is released.
Disable: automatic address assignment is locked.
FACTORY RESET
DO RESET
Warning!
This function should be used only in emergencies, since all previously set attributes are
set back to the factory setting and ,thus, secure communication and operation of the
masters with the AS-i network is no longer guaranteed.
Master and AS-i network have to be reconfigured after a successful "Reset".
For double masters the "Reset" acts on both AS-i masters!
Summary of Contents for CESA-GW-AS-PB
Page 1: ...Description AS i Gateway English Gateway AS i PROFIBUS CESA GW AS PB 749962 1002NH ...
Page 2: ......
Page 4: ......
