![background image](http://html1.mh-extra.com/html/festo/ms6-sfe-n2i-series/ms6-sfe-n2i-series_operating-instructions-manual_2282524046.webp)
MS6−SFE−...
Festo MS6−SFE−... 0507NH English
46
Setting the switching behaviour of the digital outputs in the RUN mode
Warning
Depending on the functionality of the machine/system, the manipulation of
signal states can cause serious injury to human beings and damage to property.
S
Note that if the switching status of the outputs is modified in the EDIT mode,
the new status will be effective immediately.
For flow measurement, switching points for both digital outputs (Out A/B) are
possible. A switching impulse for the accumulated consumption measurement can
then only be defined for digital output A (Out A). The combination of accumulated
consumption measurement (Out A) and flow measurement (Out B) is possible.
S
Proceed as follows:
a) Select the switching output
Switching output Out A
Switching output Out B
1.
In order to activate the EDIT mode, press the Edit button.
Only with active security blocking [Lock]:
S
Press the UP/DOWN button until the desired security code is set.
S
Press the Edit button.
[Out A] flashes.
With the UP/DOWN button the following can be selected (see also Fig.21 and Fig.22):
The output for which the behaviour is to be set (Out A or Out B)
The LOCK mode (set security code)
The RECORDER mode (only when Out A is in switching mode Flow).
2.
In order to select switching output
Out B, press the DOWN button (B).
[Out B] flashes.
3.
In order to confirm the selected output, press the Edit button.
Fig.13
Further steps see Fig.14.
Summary of Contents for MS6-SFE N2I Series
Page 30: ...MS6 SFE Festo MS6 SFE 0507NH Deutsch 30 1 1 Grundzustand RUN Modus Bild 23 SHOW Modus...
Page 32: ...MS6 SFE Festo MS6 SFE 0507NH Deutsch 32...
Page 60: ...MS6 SFE Festo MS6 SFE 0507NH English 60 1 1 Basic status RUN mode Fig 23 SHOW mode...
Page 62: ...MS6 SFE Festo MS6 SFE 0507NH English 62...