4. Commissioning
4−48
Festo P.BE−SBO−Q−EN en 0702a
4.9.6
Communication via the Ethernet interface with EasyIP protocol
The device provides the Festo Easy IP protocol for communi
cation with a higher−order controller or a Festo FED. This
makes very comprehensive output and control options poss
ible, e. g. for processing further test results in the higher−
order controller.
The support of the EasyIP protocol by the compact camera
must be activated via the system parameters.
For communication via Ethernet, FEDs generally require a bus
interface (Ethernet interface). Further information on FEDs
(and if necessary bus interfaces) can be found in the descrip
tions for the product concerned.
Reading and writing is done via the data packages assigned
by EasyIP, whereby the data to be read/written is defined by
memory addresses.
The device not only provides I/Os via memory addresses, but
also allows access to the results of a test and to the settings
of the system parameters.
Certain memory addresses can be read and written, some can
be read only or written only (see table in appendix A.6).
Installation
1. Switch the system off in order to avoid faults or damage.
Switch off the power supply for the Compact Vision Sys
tem and for the device to be con−nected (e. g. CPX−FEC or
FES).
2. Connect the Compact Vision System to the relevant device
by means of the specified cables, e. g. via an Ethernet
switch or hub.
3. Switch the power supply on again.
Summary of Contents for SBO Q Series
