02.07.04
FTE
MS-Word Dokument
Index: .
Änd-Nr.:
Anz.:
Tag:
Name:
Copyright by Festo AG & Co.
All rights reserved.
Referred to protection notice ISO 16016
.
Typ
SFE3-
TE-BST
Tag
Name
Werkstoff
gez.
23.03.04
jhz
gesehen
08.06.04
udm
Freigabe
Gefertigt aus:
Bl-Nr: 14 / 20
Maßstab:
Benennung:
Dok-Art:
Teile-Nummer:
Bed.Anleitung
DRW
678655
©
(Safety information concerning connection)
N
Connection
Deactivate power supply before connecting device. Before starting work, ensure that all persons and
tools have been electrostatically grounded. For flexible line sections use sufficiently flexible cable
material.
N
Installation
Install the device and connecting lines at the greatest possible distance from sources of interference
such as power lines. Protect the power supply line against overvoltage from inductive load.
N
Supply voltage
Supply voltage must not exceed stated value. If supply voltage is too high or if an AC-power supply is
connected, the device may be destroyed or catch fire.
N
Shorting of load circuit
The load circuit must not be short-circuited. The device may be destroyed or catch fire.
N
Incorrect connection
When connecting to power supply, ensure that the polarity is correct. Otherwise the device may be
destroyed or catch fire
.
4. Relationship between analog output voltage and flow rate
$
0
F.S
.
1
2
3
4
5
an
al
og
o
ut
pu
t (
V
)
flow rate [l/min]
(supplementary information)
The analog output signal is influenced not only by
environmental temperature characteristics, but
also by inherent warming. It is therefore
recommended to observe at least 5 min. of
pre-heating.
If the flow rate exceeds the device’s nominal
value, output analog voltage is more than 5 V
(max. 8 V).
