Festo — YXCF — 2021-07b
Assembly
73
EHMX-EGC-
50
80
120
185
Y1
1)
[mm]
By + 108
By + 182
By + 280
By + 386
X1
2)
[mm]
Hx + 51
Hx + 146
Hx + 224
Hx + 310
1) By = width in Y-direction
è
Technical data
2) Hx = stroke in X-direction
è
Technical data
Tab. 27: Dimensions for mounting kit for EHMX-EGC
EHMX-ELGC-
60
80
Y1
1)
[mm]
By + 140
By + 180
X1
2)
[mm]
Hx – 1.5
Hx – 13.5
1) By = width in Y-direction
è
Technical data
2) Hx = stroke in X-direction
è
Technical data
Tab. 28: Dimensions for mounting kit for EHMX-ELGC
EHMX-EGC-
50
80
120
185
Y1
1)
[mm]
By + 110
By + 186
By + 260
By + 395
X1
2)
[mm]
Hx + 1
Hx + 78
Hx + 118
Hx + 204
1) By = width in Y-direction
è
Technical data
2) Hx = stroke in X-direction
è
Technical data
Tab. 29: Dimensions for adjusting kit for EHMX-EGC
EHMX-ELGC-
60
80
Y1
1)
[mm]
By + 165
By + 205
X1
2)
[mm]
Hx – 69.5
Hx – 81.5
1) By = width in Y-direction
è
Technical data
2) Hx = stroke in X-direction
è
Technical data
Tab. 30: Dimensions for adjusting kit for EHMX-ELGC
1. The slides of the X-module are blocked with motor position left/right (EHMX-EGC-...-L/-R) or with
motor with brake.
To move the slides for alignment:
–
For motor with brake: demount the motor.
–
For motor without brake: remove connector terminal at the end of the motor cable.
2. Place the product slowly and carefully on the prepared mounting surface.
3. Lightly fix the product to the X-axis with energy chain on the mounting surface using the mounting
components.
Connection between X-module and Y-module
Transport may have caused the product to become distorted.
To remove distortion from the product and facilitate alignment of the X-axes:
• Slightly loosen the connection between the X-module and Y-module; do not disconnect it.
