14
Festo — YXCF — 2021-07b
Transport
•
4.3
Delivery status
The product is supplied in the status "partially assembled" or "fully assembled" according to the
order.
Delivery status "partially assembled":
–
The modules are not connected to one other.
–
The motors are mounted on the modules.
Exception with centre motor position on the X-module: the motor is mounted on the central gear
unit.
–
The cables, hoses, motor controller and motor controller accessories are enclosed.
Delivery status "completely mounted":
–
All modules are connected to one other.
–
The motors are mounted on the modules.
Exception with centre motor position on the X-module: the motor is mounted on the central gear
unit.
–
The cables and hoses are installed in the energy chains.
–
The motor controllers and motor controller accessories are included.
The product is also available without motors. Mounting third-party motors is not recommended and is
not part of these operating instructions.
5
Transport
5.1
Transportation protection
CAUTION
Risk of injury from falling parts.
Parts of the product or the transportation protection may fall during transport or unpacking.
• Observe the identification on the transportation protection.
• Unpack the product with at least 2 persons.
Transporting product
•
Transport the product to the storage location or mounting location in the transportation protec-
tion and place it on a firm, flat base.
Unpacking product
When unpacking, observe the following:
–
Use appropriate tools.
–
The parts of the transportation protection are large and heavy: make sure that parts do not fall
down and damage the product.
–
The product is secured to the transportation protection with transport locks
transportation locks from the transportation protection.
–
Use suitable aids to lift and set down the product, e.g. crane.
Lift the product out of the transportation protection with the mounted transport kit
