see whether any parts are damaged.
If external damage is present or the
machine is malfunctioning, do not
continue using the machine.
2.3
If the machine has been
damaged
– Liquid may leak from defective bat
teries. In this case, do not use the
machine and dispose of it correctly.
– In the event of a battery fire, extin
guish the fire with water. If possi
ble, completely cover the machine
with water. Call the fire service and
inform them that the fire involves
lithium-ion batteries.
– There is a risk of vapours being re
leased if the battery is damaged or
not used correctly. The vapours
may irritate your airways. Seek
fresh air and consult a doctor if you
feel unwell.
– Fluid may leak out of the battery if
it is used incorrectly. Avoid contact
with the fluid. Rinse with water any
areas which accidentally come into
contact with the fluid. If fluid gets
into the eyes, also consult a doctor.
Leaking battery fluid can cause skin
irritation or burns.
2.4
Connecting consumers
– Do not connect a consumer with
AIM technology (e.g. TKS 80 EBS
with SawStop AIM technology). AIM
technology only works with a pro
tective earth connection and an
earthed power source.
– Do not use to operate medical life
support machines.
– Do not connect any power genera
tion systems.
– For serial or parallel coupling (e.g.
with a mobile dust extractor), every
additional consumer must be con
nected using a PRCD protective
adapter [1-8] and secured (see sec
tion
– Use an antistatic suction hose when
connecting a mobile dust extractor.
– Comply with local regulations for
safe operation of electrical con
sumers at all times, especially for
operation of mobile power genera
tors.
– Use a consumer with restart pro
tection if possible.
– Do not use faulty consumers. Con
sumers, including the mains power
cable, must be in flawless technical
condition.
– During operation with connected
consumers, ensure stable footing
(ensure good access to the connec
ted consumer and sufficiently long
cable; do not place the charging ca
ble and mains power cable under
tension).
– Before connecting consumers, en
sure that the consumers are
switched off.
– Always switch off connected con
sumers after use.
2.5
Information on charging the
machine
– Only use the provided charging ca
ble [1-11] for charging.
– Charge using low-voltage networks
(120‑240 V / 50 Hz).
3
Intended use
SYS‑PST 1500 Li HP is intended for
charging and operating mobile end de
vices and power tools/consumers.
English
18
Summary of Contents for 205721
