1
2
1
2
2
2
1
1
3A
3B
3C
3D
8.2
Switch on/off
The switch [1-1] is an on/off switch (I = ON, 0 =
OFF).
When the battery pack is empty, or if there
is a power failure or the mains plug is re
moved, move the on/off switch immediate
ly to the Off position. This prevents uncon
trolled restarting.
9
Settings
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
9.1
Electronics
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Temperature cut-out
To avoid the motor overheating, the power con
sumption is limited at an excessive motor tem
perature. If the temperature continues to rise,
the power tool switches off and can only be
switched on again once the motor has cooled
sufficiently.
Constant speed
The preselected motor speed is kept constant
through electronic control. This means that, if
the machine is used as intended (reasonable
contact pressure), a constant sanding speed is
achieved.
Setting and adjusting the speed
The speed can be set [1-5] between 6000 and
10000 min
-1
using the adjusting wheel.
For sanding, we recommend the following set
tings for the adjusting wheel [1-5]:
Sanding work
Adjusting
wheel setting
–
Sanding with max. abrasion
–
Sanding off old paint
–
Sanding of wood and veneered
surface prior to paintwork
–
Intermediate sanding of paintwork
on surfaces
5 - 6
–
Sanding thinly applied undercoat
–
Sanding wood with sanding cloth
–
Edge breaking on wooden parts
–
Smoothing primed wooden surfa
ces
4 - 5
–
Sanding solid wood and veneered
edges
–
Sanding rebate of windows and
doors
–
Intermediate sanding of paintwork
at edges
–
Light sanding of natural wood win
dows using sanding cloth
–
Smoothing wooden surfaces using
sanding cloth before staining
–
Rubbing or removing excess lime
stone residue using sanding cloth
3 - 4
–
Intermediate sanding of paintwork
on stained surfaces
–
Cleaning natural wood window re
bate using sanding cloth
2 - 3
–
Sanding stained edges
–
Sanding of thermoplastics
1 - 2
9.2
Changing sanding pad [4A]
An optimal work result can only be ach
ieved using original accessories and con
sumables. The use of non-original accessories
or consumables invalidates the right to claim
under warranty.
If the StickFix coating on the sanding pad has
worn out, the entire sanding pad can be re
placed:
Undo the four screws.
Remove the sanding pad by pulling it down
wards.
Attach the new sanding pad.
English
8
