Tool`s Ampere Rat
ing
Cord Length in Meters
10-12
1.0
2.5
4.0 -
12-16
-
-
-
-
Use only NRTL listed extension cords.
Never use two extension cords together. In
stead, use one long one.
The lower the AWG number, the stronger
the cord.
9.2
Holding the power tool correctly
Type of instal
lation
Gripping surface
sand
ing head
Hold the handle [1-8] or T-han
dle [1-6] with one hand and the
sanding head pipe [1-16] with
the other hand.
ex
tension tube +
sanding head
Hold the handle [1-8] or T-han
dle [1-6] with one hand and the
extension tube [1-14] with the
other hand.
2 ex
tension tubes +
sanding head
Hold the handle [1-8] or T-han
dle [1-6] with one hand and the
first extension tube after the
handle [1-1] with the other
hand.
9.3
Sanding
► To switch on the power tool, see Sec
tion
► Place the sanding head parallel to the sand
ing surface.
► Perform the sanding work.
If the power tool beeps three times, there is a
fault. For troubleshooting, see Section
.
The restart protection prevents the ma
chine from starting automatically after the
power supply is interrupted (e.g. after a
power failure). After a voltage interruption,
switch the power tool on again.
Do not apply too much pressure on the
power tool as this will cause it to overload.
The best sanding result is achieved by the
correctly set suction power without addi
tional pressure on the power tool. The
sanding performance and quality are
mainly dependent on the selection of the
correct abrasive.
9.4
Ceiling work
WARNING
If the suction is interrupted,
there is a risk of injury from the power tool
falling and loss of control
► Always hold the power tool with both hands
using the indicated gripping surfaces, see
.
Attaching the hose clip [9]
When working on the ceiling, the hose clip pre
vents you from having to hold the hanging plug-
it mains power cable and suction hose in your
hand, and also ensures that you have unre
stricted freedom of movement.
► Pull out the mains plug.
►
Attach the hose clip to the extractor
hose and the plug-it mains power cable.
►
Hook the hose clip to the right or left
side of the T-handle.
If the hose clip is installed, it can be
hooked into or unhooked from the T-han
dle depending on whether work is being
carried out on the ceiling or on the wall.
9
English
17
