Do not dispose of the device as domestic
waste! Dispose of machines, accessories and
packaging at an environmentally responsible
recycling centre. Observe the respective nation
al regulations.
Battery Disposal
WARNING
Risk of fire or injury
► Do not attempt to disassemble the battery
or remove any component projecting from
the battery terminals.
► Prior to disposal, protect exposed termi
nals with adhesive tape to prevent short-
circuiting.
Used or faulty batteries must only be returned
to collection points if discharged and secured
against short-circuiting (e.g. by insulating the
terminals with adhesive tape). The applicable
regulations must be observed.
Batteries will then be recycled.
13 General information
13.1 Information on data privacy
The power tool contains a chip which automati
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
13.2 Information about Bluetooth
®
As soon as the tool is connected to the Festool
Work app via Bluetooth
®
and the secure con
nection has been authorised, the tool will con
nect automatically to the Festool Work app
from this point onwards. The tool then regularly
sends status information (ID, operating status,
etc.) via Bluetooth
®
.
The Bluetooth
®
word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
13.3 Federal Communications Commission
(FCC) Interference Statement
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interfer
ence in a residential installation. This equip
ment generates, uses and can radiate radio fre
quency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interfer
ence will not occur in a particular installation. If
this equipment does cause harmful interfer
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
–
Reorient or relocate the receiving antenna.
–
Increase the separation between the equip
ment and receiver.
–
Connect the equipment into an outlet on a
circuit different from that to which the re
ceiver is connected.
–
Consult the dealer or an experienced
radio/TV technician for help.
NOTE: Any changes or modifications not ex
pressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
13.4 RSS Compliance Statement
This device complies with Industry Canada’s li
cence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, in
cluding interference that may cause undesired
operation of the device. This device has been
designed and complies with the safety require
ment for RF exposure in accordance with
RSS-102, issue 5 for portable conditions.
13.5 Notes (ISED)
This Class B digital apparatus complies with
Canadian ICES-003 and RSS-210. Operation is
subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference, in
cluding interference that may cause undesired
operation of the device.
13.6 Radio frequency (RF) Exposure
Information
The radiated output power of the Wireless De
vice is below the Innovation, Science and Eco
nomic Development (ISED) radio frequency ex
posure limits. The Wireless Device should be
used in such a manner such that the potential
English
20
