13
Auxiliary handle
We recommend working with an auxiliary
handle
[5-1]
to ensure a safe, non-tiring
working posture.
Attaching the auxiliary handle [5]
Attach the auxiliary handle
[5-1]
to the neck of
the gear housing.
Turn the grip anticlockwise until the auxiliary
handle
[5-1]
is secured in position.
Depth stop
The drilling depth can be adjusted using the
depth stop
[5-2]
.
Attaching the depth stop [5-2]
Unscrew the auxiliary handle
[5-1]
by turning
the grip anticlockwise.
Insert the depth stop
[5-2]
in the auxiliary han-
dle
[5-1]
.
Pull out the depth stop
[5-2]
until the distance
between the tip of the drill and the tip of the
depth stop corresponds to the desired drilling
depth.
Tighten the grip on the auxiliary handle
[5-1]
again.
Extraction
Please observe the safety regulations applicable
in your country for dust. The relevant limit values
must be observed at the workstation.
A dust ex-
tractor may be required for corresponding dust ex-
posure and depending on regulations. Festool of-
fers a drilling dust nozzle in the accessories sys-
tem.
Use drill dust collection nozzle
The drill dust collection nozzle
[6]
has a patented
dual-chamber system for clean drilling and a se-
cure hold on floors, walls and ceilings.
If the extractor has an automatic filter cleaning
system this must be deactivated.
Put it on the wall, floor or ceiling.
Connect the dust extractor and switch it on.
The drill dust collection nozzle clings to the sur-
face.
Place rotary hammer.
5
5-2
5-1
1
2
6
6
3
1
2
Summary of Contents for BHC 18 Li
