C 12 Li, C 15 Li
15
GB
machine through the air vent slits (danger
of short circuit).
– Do not charge battery packs from external
manufacturers. The charger is designed for
charging original battery packs only. Never
charge the battery packs in chargers from
external manufacturers. Otherwise there is
a danger of fire and explosion.
– Protect the battery pack from excessive
heat or constant heat sources such as sun-
light or naked flames. There is a risk of ex-
plosion.
– Never use water to extinguish burning Li-
Ion battery packs, always use sand or a
fire blanket.
5.3
Emission levels
Levels determined in accordance with EN
60745 are typically:
Vibration emission value a
h
(vector sum for
three directions) and uncertainty K mea-
sured in accordance with EN 60745:
The emission values specified (vibration,
noise) were measured in accordance with the
test conditions stipulated in EN 60745 and
are intended for machine comparisons. They
are also used for making preliminary esti-
mates regarding vibration and noise loads
during operation.
The emission values specified refer to the
main applications for which the power tool is
used. If the electric power tool is used for
other applications, with other tools or is not
maintained sufficiently prior to operation,
however, the vibration and noise load may be
higher when the tool is used. Take into ac-
count any machine idling times and down-
times to estimate these values more accu-
rately for a specified time period. This may
significantly reduce the load during the ma-
chine operating period.
6
Operation
6.1
Changing the battery pack
[2]
L
The battery packs in the BPC series are
also suitable for use with the cordless
drills T 12+3/T 15+3 of the same voltage.
6.2
Charging the battery pack
[3]
L
The battery pack is immediately ready for
operation upon delivery and can be
charged at any time independently of its
charge state without shortening the ser-
vice life.
The charger TRC 3 can be used to charge all
Festool battery packs of the BPS and BPC se-
ries. The charger automatically detects the
type of the inserted battery (NiCd, NiMH or
LiIon). A microprocessor controls the charg-
ing process in line with the charging state,
temperature and voltage of the battery pack.
The LED
[3-1]
on the charger indicates the
respective operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack is charged to maximum capac-
ity.
LED green - flashing slowly
Battery pack is charged with reduced cur-
rent, LiIon is charged to 80 %.
LED green - lit continuously
Battery pack is fully charged, or charging is
not started again, because the battery is
charged to more than 80 %.
LED red - flashing
General fault display, e.g. incomplete con-
tact, short circuit, battery pack faulty, etc.
LED red - lit continuously
Battery temperature is outside the permitted
range.
6.3
Charger wall mount
The charger TRC 3 has two elongated holes
on its back. It can be mounted on a wall us-
ing two screws (e.g. round head or flat head
screw with shank diameter of 5 mm) (see
Fig.
[3]
).
Sound pressure level
L
PA
= 65 dB(A)
Noise level
L
WA
= 76 dB(A)
Uncertainty
K = 3 dB
CAUTION
Operating noise
Damage to hearing
X
Use ear protection!
Drilling in metal
a
h
= 3,5 m/s
2
K = 1,5 m/s
2
Screws
a
h
< 2,5 m/s
2
K = 1,5 m/s
2