16
C 12 Li, C 15 Li
GB
7
Settings
7.1
Changing direction of rotation
[1-8]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise ro-
tation
7.2
Changing gear
[1-4]
L
Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
7.3
Fastening
Adjust the switch so that
[1-7]
its marking
faces the screw
[1-6]
symbol. The torque
can be adjusted in this position.
L
The switch-over function only works if the
machine is switched off.
X
Adjust the torque accordingly at the
torque
[1-1]
wheel:
Position 1 = low torque
Position 25 = high torque
The machine switches off when the preset
torque is reached and an acoustic signal
sounds. The machine only continues running
when the on/off switch is
[1-9]
released and
then pressed again.
7.4
Drilling
Adjust the switch
[1-7]
so that its marking
faces the drilling symbol
[1-5]
. Maximum
torque is set in this position.
8
Tool holder, attachments
8.1
Tool chuck CENTROTEC WH-CE
[4]
The tool chuck CENTROTEC WH-CE allows
you to change tools with a CENTROTEC
shank in a matter of seconds.
L
Always use a CENTROTEC tool chuck to
clamp CENTROTEC tools.
8.2
Chuck BF-FX
[5]
The chuck BF-FX is used for clamping drill
and screwdriver bits.
8.3
Angle attachment DD-AS
[6]
The angle attachment DD-AS (in part, addi-
tional equipment) permits drilling and screw-
driving at a right angle to the machine.
8.4
Eccentric attachment DD-ES
[7]
The eccentric attachment (in part, additional
equipment) permits screwdriving near edges
with bits according to DIN 3126.
8.5
Tool holder in the drill spindle
[8]
Bits can be inserted directly in the hexagon
socket holder on the drill spindle to shorten
and reduce the weight of the machine.
9
Working with the machine
9.1
On/Off switch
[1-9]
Press = ON, release = OFF
L
The speed of the machine depends on
how far the on/off switch is pressed in.
The LED lamp
[1-3]
lights up when the on/off
switch
[1-9]
is pressed and lights up the
working area.
9.2
Bit store
[1-2]
The magnetic bit store is designed for hold-
ing bits or bit holders.
9.3
Acoustic warning signal
Acoustic warning signals sound and the ma-
chine switches off in the following operating
states:
– Battery flat or machine overloaded.
X
Change the battery.
X
Place the machine under reduced stress.
WARNING
Risk of injury, electric shock
X
Always disconnect the battery pack before
any type of work on the machine!
CAUTION
Tool has sharp edges and can cause cut-
ting injuries during a tool change.
X
Wear protective gloves!
CAUTION
Risk of injury
X
Clamp the tool centrally in the chuck!
peep ― ―
