Connecting a mains-powered power tool to the
mobile dust extractor
► Connect the power tool to the electric outlet
module [1-2].
The power tool is connected the to mobile dust
extractor via the power cable.
Connecting a battery-powered power tool to
the mobile dust extractor (MINI I / MIDI I)
► In standby mode, press the connection but
ton [1-20].
The connection display [1-19] flashes slow
ly. For a period of 60 seconds, the mobile
dust extractor is ready for connection.
► Turn on the battery-powered power tool.
The mobile dust extractor starts up and the
battery-powered power tool is connected
until the mobile dust extractor is manually
switched off or the mains plug is disconnec
ted. The battery-powered tool must then be
connected again.
Connecting a new battery-powered power tool
overwrites the previous connection.
6.4
Connecting a mobile device (MINI I /
MIDI I)
A mobile device (e.g. smartphone) can be con
nected to the mobile dust extractor via
Bluetooth
®
(e.g. for a software update with the
Festool app).
► Hold down the connection button [1-20] on
the mobile dust extractor for three seconds
in standby mode.
The connection display [1-19] flashes rapid
ly.
For a period of 60 seconds, the mobile dust
extractor is ready for connection.
► Follow the instructions provided in the
Festool app.
6.5
Remote control (MINI I / MIDI I)
Connecting the remote control and mobile
dust extractor
To be able to connect a remote control to a mo
bile dust extractor, the remote control must be
reset (see "Resetting the remote control").
Remote controls that have not been connected
previously can be connected directly.
A connection that has been created be
tween remote controls and the mobile
dust extractor will persist even after the
mobile dust extractor has been manually
switched off or the mains plug has been
disconnected.
The mobile dust extractor can be connec
ted to as many as five remote controls at
the same time. The mobile dust extractor
can only be connected to one cordless
power tool at a time.
► Hold down the connection button [1-20] on
the mobile dust extractor for three seconds
in standby mode.
The connection display [1-19] flashes rapid
ly.
For a period of 60 seconds, the mobile dust
extractor is ready for connection.
► Press the MAN button on the remote con
trol.
The remote control is permanently stored in
the mobile dust extractor.
Switching on/off
Once the remote control is connected to the
mobile dust extractor, the mobile dust extractor
can be switched on and off with the remote con
trol.
► Press the MAN button on the remote con
trol to switch the device on and off.
Resetting the remote control
Resetting deletes the connection between a re
mote control and the mobile dust extractor.
► Hold down the connection button and the
MAN button for 10 seconds.
The LED indicator lights up purple, if the re
set has taken place.
6.6
Delete all saved devices. (MINI I / MIDI
I)
► Press and hold the connection button [1-20]
for at least three seconds.
The connection display [1-19] flashes rapid
ly.
► Press and hold both the plus and minus
button [1-18] for at least three seconds.
The mobile dust extractor confirms the com
mand by rapidly flashing three times.
7
Settings
7.1
Adjusting the suction power
► Press the plus or minus button [1-18] while
extracting.
7.2
Temperature cut-out
A temperature cut-out switches the mobile dust
extractor off when it reaches a critical tempera
ture to prevent overheating. The bottom
LED [1-18] indicates a fault.
English
18
