6
6-5
6-6
6-7
6-4
6-1
6-3
6-2
6-8
Fine adjuster
The fine adjuster (available as an accesso
ry, [7-5]) can be used to precisely adjust dis
tance X.
► Install the fine adjuster [7-5] on the guide
rods between the power tool and the guide
rail adapter [7-4].
► Insert the adjusting wheel [7-2] into the
guide rail adapter, as shown in the fig
ure [7].
► Screw the adjusting wheel [7-2] into the
nuts of the fine adjuster.
To adjust distance X:
► Open the rotary knob [7-1] for the guide rail
adapter and close the rotary knob [7-3] for
the fine adjuster.
► Adjust to required distance X by turning the
adjusting wheel [7-2].
► Close the rotary knob [7-1] for the guide
rail adapter.
7
7-1
7-2
7-3
7-5
7-4
9.4
Copy cutting
A copying ring or the copying device is used to
exactly reproduce existing workpieces (acces
sories).
Copying ring
When choosing the size of the copying ring, en
sure that the cutter being used fits through its
opening.
Excess Y (figure [9]) of the workpiece to the
template is calculated as follows:
Y = (copying ring diameter - cutter diameter)/2
► Attach the copying ring [8-1] to the router
table: Insert the two tenons [8-2] into the
recesses [8-3].
► To remove the copying ring: Press the two
buttons [1-16] inwards at the same time.
English
14
