Cordless drill
T18+3
Weight (incl. battery pack BP 18 Li 6,2 AS and chuck) as per EPTA procedure
01:2014
2 kg
Weight with Centrotec, without battery pack.
1.0 kg
* Speed specifications with fully charged bat
tery pack.
** The maximum speed is reduced in the lower
torque stages (values in clockwise rotation).
5
Functional description
[1-1]
Buttons for releasing the battery pack
[1-2]
Capacity display button on battery
pack
[1-3]
Capacity indicator
[1-4]
Bit store
[1-5]
On/off switch
[1-6]
Rotational direction switch
[1-7]
LED light
[1-8]
Gear switch
[1-9]
Drilling symbol
[1-10] Screwdriving symbol
[1-11] Screwdriving/drilling selector switch
[1-12] Torque thumbwheel
[1-13] Belt clip
[1-14] Insulated gripping surfaces (grey
shaded area)
Accessories shown or described are not always
included in the scope of delivery.
The specified illustrations appear at the begin
ning of the Operating Instructions.
6
Commissioning
6.1
Belt clip
The belt clip allows a shot-term securing of the
device in the work clothes. Insert the belt clip
on the designated side, right or left, and fix it
with the screw [1a].
6.2
Switching on/off [1-5]
Press = ON, release = OFF
The speed can be infinitely adjusted, rela
tive to the pressure applied to the on/off
switch.
The LED light [1-7] lights up when the on/off
switch [1-5] is pressed.
7
Battery pack
7.1
Changing the battery pack
Inserting the battery pack [2a]
Removing the battery pack [2b]
The battery pack is ready to use straight out of
the box and can be charged at any time.
7.2
Capacity indicator
The capacity display [1-3] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-2] is pressed:
70–100%
40–70%
15–40%
< 15%
*
*
Recommendation: Charge the battery pack
before any further use.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8
Settings
CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
8.1
Changing direction of rotation [1-6]
–
Switch to the left = clockwise rotation
–
Switch to the right = counterclockwise rota
tion
8.2
Changing gear [1-8]
Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
•
Gear switch forwards (digit 1 visible) =
1st gear
•
Gear switch to rear (digit 2 visible) =
2nd gear
English
15
