13
Eccentric attachment DD-ES [6]
Screwdriving near edges with bits according to ISO
1173 (partly as accessory).
Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
Working with the power tool
Consider the pictures on the fold-out page.
On/Off switch [1-3]
Press = ON, release = OFF
The speed of the machine depends on how far
the on/off switch is pressed in.
The LED bulb
[1-5]
lights up when the ON/OFF
switch is pressed
[1-3]
.
Bit store [1-2]
Magnetic, for storing bits and bit holders.
Acoustic warning signals
Acoustic warning signal sounds and the machine
switches off to indicate the following operating
states:
6
DD-ES
2
3
1
7
WARNING
Risk of injury
Always secure the workpiece in such a manner
that it cannot move while being machined.
Battery low or machine over-
loaded.
– Change the battery.
– Reduce machine workload.
Machine is overheating.
– You must allow the machine to
cool down before further usage.
Battery pack faulty or overheated.
– Once the battery pack has cooled
down, perform a function check
using the charger.
