16
OPERATION
Leveling Instructions
NOTICE!
A LEVEL UNIT SHOULD HAVE NO VISIBLE SPACES BETWEEN CUTTING EDGES AND
PLOWING SURFACE.
Scoop Position
If the front corners of the attachment are contacting the plowing surface and a gap is visible towards the
center of the attachment (figure 2):
1. Lift attachment
2. Roll attachment backwards
3. Lower back to ground
4. Continue until level.
If the rear center of the attachment is contacting the plowing surface and a gap is visible towards the outer
sides of the attachment (figure 3):
1. Lift attachment
2. Roll attachment forward
3. Lower back to ground
4. Continue until level
V Position
If the front corner of the attachment is contacting the plowing surface and a gap is visible towards the outer
sides of the attachment (figure 2):
1. Lift attachment
2. Roll attachment backwards
3. Lower back to ground
4. Continue until level.
If the outer sides of the attachment are contacting the plowing surface and a gap is visible towards the
center of the attachment (figure 3):
1. Lift attachment
2. Roll attachment forward
3. Lower back to ground
4. Continue until level
Summary of Contents for V-Snow Blade
