21
OPERATION
General Storage:
NOTICE!
Do not store in direct sunlight. Materials will deteriorate prematurely if stored in direct
sunlight. Do not store near intense heat.
Storage:
• Clean the unit thoroughly, removing all mud, dirt and grease.
• Inspect for visible signs of wear, breakage or damage. Order any parts required and make the
necessary repairs to avoid delays upon removal from storage.
• Tighten loose nuts, capscrews and hydraulic connections.
• Coat exposed portions of the cylinder rods with grease.
• Lubricate grease fittings.
• Seal hydraulic system from contaminants and secure all hydraulic hoses off the ground to help prevent
damage.
• Store unit in a dry and protected place. Leaving the unit outside will materially shorten its life.
Additional Precautions for Long Term Storage:
• Touch up all unpainted surfaces with paint to avoid rust.
• Inflate tires to recommended tire pressure.
• Fill fuel tank and hydraulic oil tank to maximum.
• Check antifreeze properties and drain fluids as appropriate.
Removal from Storage:
• Remove cover.
• Wash unit and replace any damage and/or missing parts.
• Lubricate grease fittings.
• Check hydraulic hoses for damage and replace as necessary.
Summary of Contents for V-Snow Blade
