Sidus F1Q – free flight electronic timer
6/8
servo 1
servo 2
servo 3
Position
Servo position pattern modification
This setting is intended to modify the pattern of servo(s) position(s) associated to each
function.
1. Have the Timer and Programmer close to each other with the IR sensors
mutually visible and make sure that the Timer is ON (red LED ON)
2. Press T4 (SET) (for over 3 seconds) until the SET menu is entered
3. Press and release T4 (Servos) to enter the Servo menu:
4. Press T3 or T4 to move through the patterns associated to each position (START,
POS1, POS2, POS3, POS4, POS5, POS6, DT). The servo(s) move accordingly and
the current setting is displayed (positions range from 000 to 130) for each of them.
Reach the wished position (e.g. POS2)
5. Press and release T1 to have an ‘*’ (asterisk) appearing in turn close to one of the
displayed positions. Reach the position to be changed and keep T1 pressed until the ‘*’
turns into ‘w’ (write).
Press and release now T3 or T4 to adjust the servo position for the current step: the servo
moves accordingly. The new positions are permanently stored.
START 000 000
START 000 000
START 000 000
START 000 000
000
000
000
000
POS2 *000 000
POS2 *000 000
POS2 *000 000
POS2 *000 000
000
000
000
000
Buzz
Buzz
Buzz
Buzz
E
EE
Exit
xit
xit
xit Servo
Servo
Servo
Servos
ss
s
POS2 w000 000
POS2 w000 000
POS2 w000 000
POS2 w000 000
000
000
000
000
POS2 000 0
POS2 000 0
POS2 000 0
POS2 000 000
00
00
00
000
000
000
000
SET menu
Servo menu
