Position 50
Parts are in
bag K
Plastic part for stif-
fening brace
Front plastic
fixing plate
Plastic part for
reinforcing brace
only for Baja
Position 49
Parts are in
bag K
Marder/
Baja Buggy
Rear damper
plate 4WD
Roll bar
Screw
M4x8
Alloy c
hassis
Screw
M4x8
Screw
M4x20
Screw
4,2x13
Screw
4,2x22
Plug pr
otection
only for Baja
Plastic
brace long
Plastic
brace short
Spoiler mount
Rear body
mount only for
Baja
Rocker
panel left
1.
Dismount the left and right rocker panels from your existing
2WD model and fix them to the alloy chassis by using M4x8 pan-
head screws.
2.
Remove the complete rear spoiler mount from your existing
2WD model and fix it at the rear 4WD shock mount using M4x20
cylinder screws and M4 stop nuts.
3.
Mount the long plastic braces with M4x50 headless pins (for
Marder only with 4,2x32 pan-head screws) and plastic parts for
reinforcing brace to the roll bar.
1.
Dismount the front roll bar from your existing
2WD model.
2.
Remove screws 2,9x9,5 from the alloy cover
and front alloy plate. Dismount front roll bar
parts and plastic braces for cover.
3.
Mount the front roll bar parts and the plastic
braces for the cover to the long alloy braces
Baja 4WD, then push the complete part into the
plastic part for stiffening brace and in the front
plastic fixing plate as described in position 50.
4.
Bore out the front alloy plate and the alloy
cover with a 2,5mm drill as pictured and fix
them to the long alloy braces 4WD Baja by
using 2,9x9,5 pan-head screws.
Position 51
Parts are in
bag K
Baja Buggy
Front part
roll bar
Screw
2,9x9,5
Screw
2,9x9,5
Long alloy
brace Baja 4WD
Front
alloy plate
Alloy cover
Plastic brace for
cover
Drill 2,5mm