When mounting pay attention that the clo-
sed side of the lower belt channel faces
upwards. The teeth of the toothed belt are
not allowed to touch each other.
Toothed belt
Rear axle mount
left
Rear axle mount
right
Upper part belt
channel
Lower part belt
channel
Position 5
Parts are in
bag B+C
1.
Put the toothed belt around the rear differential gear
as described in position 5.
2.
Press the left and right rear axle mounts on the ball
bearings of the rear differential gear as pictured.
3.
Put the left and right rear axle mounts on the alloy
chassis and fix them with the 4,2x16 countersunk
screws on the chassis.
1.
Place the lower part of the belt channel (with the closed side facing
upwards) on the bottom part of the toothed belt. Then push the top part
of the belt channel in the bottom part. Now insert the complete belt
channel in the opening of the front axle housing (see position 5a). Make
sure that the toothed belt is running smoothly.
2.
Fix the belt channel from underneath to the alloy chassis using the
4,2x16 countersunk screws.
Toothed belt wheel
12 teeth
Front axle
housing left
Front axle
housing right
Toothed belt
Deflection roller
16mm
Front differential
mounted
Position 3
Parts are in
bag C
1.
Impress ball bearings 6x16x6 in both front
axle housings left and right.
2.
Mount front differential gear, deflection roller
16mm, toothed belt wheel 12 teeth in the left
front axle housing as described in position 3.
3.
Now put the toothed belt on the front dif-
ferential gear, also deflection roller 16mm,
toothed belt wheel with 12 teeth as descri-
bed in position 3.
4.
Press the right front axle housing on the front diffe-
rential gear, also deflection roller 16mm and the toot-
hed belt wheel with 12 teeth (position 4).
5.
Put the complete front axle housing on
the alloy chassis and fasten it using the
4,2x16 countersunk screws.
Front axle
housing left
Front axle
housing right
Alloy chassis
Front differential
gear
Countersunk
screw M4,2x16
Countersunk
screw M4,2x16
Position 4
Parts are in
bag C