11.5.Over-discharge protector
If the battery capacity is fully discharged, permanent damage of lithium batteries will be
caused. Therefore, Joy-Rider battery is installed with over-discharge protector. When the
lithium battery is exhausted, the protector will automatically cut off the circuit and the
joystick controller will stop working.
When the red LED light of the battery power display is flickering, it means that the battery
needs to be charged.
!
When the battery is out of power, please charge within one week.
!
11.6.Over-current protector
Joy-Rider is also installed with the over-current protector. If the current supplied to the
motor is too high, the over-current protector will cut off the current supply. If hill climbing is
attempted at more than 12 degrees, or the load is more than 255Ibs, or the motor
encounters cycle blockage, the over-current protector will be started, the main controller
will cut off the circuit to prevent motor current overloading and overheating.
!
Attention
Do not open the battery and expose the acid substances to the skin, clothing or other
materials. The substance is extremely dangerous to can cause burns. If touching,
immediately rinse with cold water and seek medical treatment.
24
