Manual for motor FM 170 B2 - FS ( Date of publication 06/2016)
FIALA PROP s.r.o, Vysoká 56, 75641 LEŠNÁ , Czech Republic , e-mail: valachmotors@fialaprop.cz
www.fialaprop.com
Page 5
If a situation arises that the engine will not start, there was either a glut motor fuel, or vice versa
engine is lean.
Because these conditions can be difficult to detect, we recommend the following procedure:
- Check the fuel system (leaks, throughput, level of fuel etc.).
- Make sure that the ignition is switched off
- Set full throttle
- 10 x spin the motor
- Turn the ignition
- Set a slightly increased idle speed of about 3-8% (must be tested on a specific motor)
- Start the motor
If the engine can no longer run, we recommend:
- Make sure that the ignition is switched off
- Close the choke
- 3-4 times to spin the motor, in order to draw fuel
- Open the choke and set the throttle
- 1 x spin the motor
- Set a slightly increased idle speed of about 3-8% (must be tested on a specific motor)
- Turn the ignition
- Start the motor
If the engine still does not start, it is necessary to contact an authorized service center or the
manufacturer directly.
7.
Running motor
Each motor is factory-tested and adjusted to the basic setting. Use a fuel with a higher ratio of oil
(see section 3 of this manual), ie. 1:25. While running is not recommended long term exceed the
motor speed 2500 / min while controlling the temperature of the engine. Do not keep a constant
speed but motor flush with the occasional addition / slow down the gas. This mode observe about
the first 30 minutes of operation. After a short time, you can gradually increase the speed up to 4000
/ min. Total time of run is about 2 hours.
