Display panel mount for magnetic band
F8P
Data: 13/01/16
F8P_ing.doc
pag 2/9
Manual purpose
This manual has been designed by the Manufacturer to provide the necessary information
regarding the instrument F8P_ to those who are authorized to carry out safely its installation,
maintenance, dismantling and disposal. All the necessary information for the buyers and planners
can be found in the Sales catalogue. Other than adopting good technical construction methods,
the information should be read carefully and strictly applied. Inobservance of this information could
cause risks for the health and safety of people and economical damage. This information,
provided by the Manufacturer in the original language(Italian) is also available in other languages
to satisfy legislative and/or commercial needs. This manual must be kept in good conditions by a
responsible person in an ideal place so that it is always available for consultation. In case this
manual is lost or deteriorates, a replacement should be requested directly from the manufacturer
quoting the manual’s code. This manual reflects the state of skill of the instrument at the time of
input on the market: however the manufacturer reserves the right to make changes, add or
improve the manual without giving any reason to hold the present manual inadequate.
Identification of the equipment
The identification plate represented is applied on the instrument.
To find out the identification code of the instrument, consult the sales catalogue.
Environmental conditions
Temperature setting: min. 0°C, max. + 50°C.
It is forbidden to use the instrument other than its specific use and in potentially explosive
conditions or where anti- explosive elements are used.
Storage
Here below are some references to be followed for the storage of the instrument.
Avoid environments with excessive humidity and those exposed to bad weather (avoid open
areas). Avoid putting the instrument directly on the ground. Store the instrument in its original
packing.
Conformity declaration and EC marking
The instrument answers to the following Communitarian Directives:
2014/30/EU Electromagnetic compatibility, 2011/65/EU RoHS.
Maintenance
The instrument does not needs a particular maintenance except cleaning to do only with a soft
cloth dampen with ethylic alcohol or water. Do not use hydrocarbon solvents (petrol, diluents, etc.):
the using of these products could affect the proper functioning of the instrument.
Reparations should be done only and exclusively at the FIAMA technical assistance centre.
Calibrations and tests
It is advisable to calibrate the instrument periodically, once every working year.
To do the calibration, follow the calibration procedure indicated in the present manual.
Assistance request procedure
For any kind of technical assistance request, contact the sales department of the Manufacturer
directly indicating the information given on the identification plate, the number of hours used and
the type of defect.
Manufacturer’s responsibility
The manufacturer declines any responsibility in case of :
• Using the instrument contrary to the national safety and accident-prevention laws.
• Wrong installation, inobservance or wrong procedures of the instructions provided in the present
manual.
• Defective electrical power supply.
• Modifications or tampering.
• Operations carried out by untrained or unqualified staff.
The safety of the instrument also depends on the strict observance of the procedures indicated in
the manual: always operate the instrument in its functioning capacity and carry out a careful
routine maintenance.
• All phases of inspection and maintenance should be done by qualified staff.
