Positioning unit
Date: 08/02/21
File: Servo3M_M12_ing.doc
page 6/8
POWER 24VDC
Power supply terminal board
TERMINAL
BOARD
CONNECTION
+
24V power supply
-
GND power supply
Power connector
M12-T male as viewed externally with exit shaft directed downwards
M12T PIN
CONNECTOR
WIRE
COLOR
CONNECTION
1
BROWN
+24V POWER SUPPLY
2
WHITE
NOT CONNECTED
3
BLUE
GND POWER SUPPLY
4
BLACK
NOT CONNECTED
SETTINGS OF ADDRESS AND BAUD RATE
Before setting SERVO it is necessary to set the address and baud rate of device using dip-switch S1 and S2
as showed in the following table according to the model of SERVO used.
If the SERVO is the last node of net, set at ON the dip-switch S3 (both switches 1 and 2 at ON).
IMPORTANT: during this phase it is advisable to pay close attention to not damage the dip-switch and the
electronic components on the board. It is strictly forbidden to take off the card of its case.
Assemble the wiring clip jumper to assure the continuity of shield mostly for the Profibus cables.
2
3
1
4
