FIAP Aqua Active Eco
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
5
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
www.fiap.com
Entsorgung
Das Gerät ist gemäß den nationalen gesetzlichen Bestimmungen zu entsorgen. Fragen Sie Ihren
Fachhändler.
Störung
Störung Ursache Abhilfe
Das Gerät saugt nicht
Netzspannung fehlt
Laufrad blockiert/läuft trocken
Netzspannung überprüfen
Reinigen/Zuleitungen
kontrollieren
Wasserlauf ungenügend
Filterschale verschmutzt
Schlauch verstopft
Schlauch geknickt
Zu hohe Verluste in den
Schlauchleitungen
Reinigen
Reinigen, ev. ersetzen
Schlauch prüfen, ev. ersetzen
Schlauchlänge auf nötiges
Minimum reduzieren
Gerät schaltet nach kurzer
Laufzeit ab
Filterschale verstopft
Läuft trocken
Reinigen
Zuleitung kontrollieren
FIAP Aqua Active Eco
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
6
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
www.fiap.com
GB
Information about this operating manual
Please read the operating instructions and familiarise yourself with the unit prior to using it for the first
time. Adhere to the safety information for the correct and safe use of the unit.
Intended use
FIAP Aqua Active Eco 4.500 – 20.000, in the following text termed unit, has been exclusively produced
for pumping normal pond water for filters, water falls and water courses and has to be used at a water
temperature of between 4°C and +35°C. The unit performance can only be controlled by an FIAP
Controll Active. The unit is frost proof.
The unit is suitable for use for
swimming and bathing ponds
in accordance with the national installer
regulations.
Use other than that intended
Danger to persons can emanate from this unit if it is not used in accordance with the intended use and
in the case of misuse. If used for purposes other than that intended, our warranty and operating permit
will become null and void.
CE Manufacturer’s Declaration
We declare conformity in the sense of the EC directive, EMC directive (89/336/EEC) as well as the low
voltage directive (73/23/EEC). The following harmonised standards apply:
EN 60335-1, EN 60335-2-41, EN 55014-2, EN 61000-3-2, EN 61000-3-3
Safety information
For safety reasons, children and young persons under 16 years of age as well as persons who
cannot recognise possible danger or who are not familiar with these operating instructions, are
not permitted to use the unit!
Please keep these operating instructions in a safe place! Also hand over the operating instructions
when passing the unit on to a new owner. Ensure that all work with this unit is only carried out in
accordance with these instructions.
The combination of water and electricity can lead to danger to life and limb, if the unit is incorrectly
connected or misused. Only operate the unit if no persons are in the water! Prior to reaching into the
water, always disconnect the power supply to all units used in the water. Compare the electrical values
of the power supply with those on the type plate on the packaging or on the unit itself. Ensure that the
unit is fused for a rated residual current of max. 30 mA via a residual current-operating system. Only
operate the unit when plugged into a correctly fitted socket. Keep the power plug and all connection
points dry! Protect the connection cable when burying to avoid damage. Only use cables, equipment,
adapters, extension or connection cables with an earthed contact and approved for outside use. Do not
carry or pull the unit by the connection cable! Never operate the unit if the cable or housing are
defective! The power connection cable of this unit cannot be replaced. If the cable is damaged, the
entire unit has to be disposed of. Electrical installations at garden ponds must meet the international
and national regulations valid for installers. Never open the unit housing or its attendant components,
unless this is explicitly mentioned in the operating instructions. Never carry out technical changes to
the unit. Only use original spare parts and accessories. Only allow authorised customer service outlets
to perform repairs. Never run the unit without water! Never use the pump for fluids other than water!
For your own safety, consult a qualified electrician if you have questions or encounter problems!
