FIAP SpaltSkim Active
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
10
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
Assembly
For an optimal degree of efficiency the device for the suction of the water-surface (FIAP SpaltSkim
Active) should be mounted against the main wind direction. The main wind direction is mostly the east
bank. So the dirt-particles can float perfectly in the direction of the suction-opening. To support this
process you can create additional water-streaming. During installation make sure that no plants or
rocks are placed in front of the suction-opening. They can reduce the efficiency of the device for the
suction of the water-surface (FIAP SpaltSkim Active).
Installation according to the sequence of the pictures
1.
Use a skimmer-flange for marking.
2.
When made out of metal sheet, plastic material or fiber glass drill with a drill machine a hole in
each of the four corners, inside the marking of the skimmer-flange. If it is a pond-foil then use a
sharp knife for this.
3.
With a jigsaw you cut the metal-sheet, plastic material, fiber glass and so on out.
4.
If necessary use a file to true and strip the cut.
1
2
3
3
