Vehicles equipped with the Anti-Lock Brake Sys-
tem (ABS) are also equipped with Electronic
Brake Force Distribution (EBD)
.
In the event of
an EBD failure, the Brake Warning Light will turn
on along with the ABS Light
.
Immediate repair to
the ABS system is required
.
Operation of the Brake Warning Light can be
checked by turning the ignition switch from the
OFF position to the ON/RUN position
.
The light
should illuminate for approximately two seconds
.
The light should then turn off unless the parking
brake is applied or a brake fault is detected
.
If the
light does not illuminate, have the light inspected
by an authorized dealer
.
The light also will turn on when the parking brake
is applied with the ignition switch in the ON/RUN
position
.
NOTE:
This light shows only that the parking brake is
applied
.
It does not show the degree of brake
application
.
— Electronic Throttle Control (ETC)
Warning Light
This warning light will illuminate to inform of a
problem with the Electronic Throttle Control
(ETC) system
.
If a problem is detected while the
vehicle is running, the light will either stay on or
flash depending on the nature of the problem
.
Cycle the ignition when the vehicle is safely and
completely stopped and the transmission is
placed in the PARK position
.
The light should turn
off
.
If the light remains on with the vehicle
running, your vehicle will usually be drivable;
however, see an authorized dealer for service as
soon as possible
.
If the light continues to flash when the vehicle is
running, immediate service is required and you
may
experience
reduced
performance,
an
elevated/rough idle, or engine stall and your
vehicle may require towing
.
The light will come on
when the ignition is placed in the ON/RUN or
MAR/ON/RUN position and remain on briefly as
a bulb check
.
If the light does not come on during
starting, have the system checked by an autho-
rized dealer
.
— Engine Coolant Temperature Warn-
ing Light
This warning light warns of an overheated engine
condition
.
If the engine coolant temperature is
too high, this indicator will illuminate and a single
chime will sound
.
If the temperature reaches the
upper limit, a continuous chime will sound for
four minutes or until the engine is able to cool:
whichever comes first
.
If the light turns on while driving, safely pull over
and stop the vehicle
.
If the A/C system is on, turn
it off
.
Also, shift the transmission into NEUTRAL
and idle the vehicle
.
If the temperature reading
does not return to normal, turn the engine off
immediately and call for service
.
Refer to “IfYour Engine Overheats” in “In Case Of
Emergency” for further information
.
— Seat Belt Reminder Warning Light
When the ignition is first placed in the ON/RUN
or MAR/ON/RUN position, if the driver’s seat
belt is unbuckled, a chime will sound and the light
will turn on
.
When driving, if the driver or front
passenger seat belt remains unbuckled, the Seat
GETTING
T
O
KNO
W
Y
OUR
INSTR
UMENT
PANEL
40
Summary of Contents for 500 L 2019
