63
Capron - 04-17 - CAP-0017-01
EN
Living
7
Opening:
Lift the mattress forwards.
Lift slatted frame. The gas-pressure springs (Fig. 54,1) hold the slatted
frame open.
Closing:
Press the slatted frame downwards against the resistance of the gas-pres-
sure springs.
7.9.5
Lying surface of rear single beds
Depending on the equipment, the single beds in the rear may be transformed
into a continuous lying surface.
Pull the width extension out of the console between the beds.
Insert the supplied additional cushion.
7.10
Converting seating groups for sleeping
7.10.1
Central seating group
Convert the table to a bed foundation (see section 7.6.1).
Remove and put aside one back cushion.
Place one seat cushion onto the table.
Place one back cushion flatly on the bench.
Insert the additional cushion between back cushion and seat cushion.
Z
Depending on the model, the seating group can be different in shape and
position to the one shown here.
Z
Depending on the model, an enclosed additional cushion must be inserted
between the seat cushions.
Fig. 55
Prior to conversion
Fig. 56
After conversion
Summary of Contents for Capron A361
