96
Capron - 04-17 - CAP-0017-01
EN
Appliances
10
Operating modes
The hot-water heater with the boiler can be operated with various energy
sources.
Selecting operating mode:
Turn rotary push button (Fig. 82,6) until the menu symbol operating mode
(Fig. 83,3) flashes.
Press rotary push button.
Turn rotary push button until the desired operating mode is displayed:
z
Gas operation
z
Electrical operation (900 W)
z
Electrical operation (1800 W)
z
Gas and electrical operation (900 W)
z
Gas and electrical operation (1800 W)
Press the rotary push button to save the set operating mode. To revert to
the original setting: Press back button (Fig. 82,7).
The combination of gas operation and 240 V electrical operation shortens the
time required to heat up the vehicle.
Setting the fan:
Turn rotary push button (Fig. 82,6) until the fan menu symbol (Fig. 83,4)
flashes.
Press rotary push button.
Turn rotary push button until the required value is displayed:
z
OFF: Fan is switched off.
z
VENT: Air circulation
z
ECO: Low fan setting
z
HIGH: High fan setting
z
BOOST: Fast room heating. Boost is available if the current room tem-
perature is at least 10 °C below the selected room temperature.
Press rotary push button to save the value set. If you do not wish to change
the value originally set: Press back button (Fig. 82,7).
Setting the timer:
Turn rotary push button (Fig. 82,6) until the timer menu symbol (Fig. 83,9)
flashes.
Press rotary push button. The start time is displayed and the hour display
flashes.
Turn rotary push button until the hour of the selected start time is displayed.
Press rotary push button. The minute display flashes.
Turn rotary push button until the minute of the selected start time is dis-
played.
Press rotary push button.
Proceed in the same way to set the switch-off time, the required room tem-
perature, the hot water setting and the fan setting.
Press rotary push button. The timer is activated. The timer symbol
(Fig. 83,9) flashes when the timer is programmed and active.
Z
240 V electrical operation is only possible when the vehicle is connected to
the 240 V power supply.
Z
Select the output level for 240 V electrical operation so that it corresponds
to the fuse protection of the 240 V connection (900 W for 3.9 A fuse,
1800 W for 7.8 A fuse).
Summary of Contents for Capron A361
