The navigator CD-ROM player
7-fig.
1
is located on the CONNECT Nav+
front panel and it is the same used for
the audio CD. Therefore, it is not pos-
sible to use the player for audio and
navigation CD-ROM at the same time:
however, the navigation system can
operate partially even without insert-
ing the navigation CD-ROM.
In this case, when pressing key
˚
8-
fig.1
to remove the CD-ROM with
navigation function engaged (to then
insert an audio CD), the following two
cases may occur:
1
) If no route has been calculated,
when ejecting the CD ROM only the
information on the car position (co-
ordinates)
fig. 94
will be available.
2
) The route previously calculated is
still valid, the system provides the user
with any instruction to reach the des-
tination.
If the route previously calculated is
still valid, the system will show the
screen in
fig. 95
.
If the user selects and confirms
“YES”, the system will store the navi-
gation data required to reach the set
destination; this operation requires a
few seconds and the display will
prompt the message to wait
fig. 96
.
After loading, the CD-ROM is eject-
ed and the system restarts its naviga-
tion function with the maximum scale
of “2 km”; therefore it may be possi-
ble that not all of the route is visible.
If the user selects and confirms
“NO”, route guide will be deactivated
and the display will go back to screen
in
fig. 94
.
Moreover, navigation in these con-
ditions involves limitations and there-
fore some functions and commands
will not be available. Also information
shown on the map will be limited.
95
CONNECT NA
V+
NAVIGATION CD-ROM PLAYER
fig. 94
F0Q3125g
Select address
Visualization
Voice bookmarks
Zoom
Delete destination
06
DEST 1
DEST 2
INFO
ATLANTE
DETOUR
MAP
Set
fig. 95
F0Q3126g
06
DEST 1
DEST 2
INFO
ATLANTE
DETOUR
MAP
Select address
Visualization
Voice bookmarks
Zoom
Delete destination
Set
fig. 96
F0Q3127g