40
automatIon
22.6: CONVERTING BLOCK SCENE TO LUA SCENE
1. Open the Configuration interface.
2. Go to
>
Scenes.
3. Click next to the scene you want to duplicate.
4. Click Copy & Convert to confirm.
22.7: SCENARIOS
You can set up Scenarios. These are special scenes that allow you to
control your roller shutters in the morning and in the evening.
The available scenarios:
•
Morning scenario
– the possibility to set the roller shutters to raise,
lower or move to a favourite position at sunrise or at a specific time.
•
Evening scenario
– the roller shutters can be set to raise, lower or
move to your favourite position at sunset or at a specific time.
A list of scenarios is available during adding a scene.
Adding a Scenario:
1. Open the Configuration interface.
2. Go to
>
Scenes.
3. Click Add scene.
4. Click Scenario.
5. Select the Morning Scenario or the Evening Scenario.
6. Configure the actions to be performed.
7. The list of available Scenarios will be available on the Scenarios tab.
22.8: FAVOURITE ROLLER SHUTTER POSITIONS
During scenario creation, you can use your favourite roller shutter
positions.
•
Intermediate position
- comfortable opening, providing shade
from the sun while keeping out the light in the room.
•
Unsealed position (Ventilation)
- minimum opening, providing
security while keeping the outside air flowing in.
Adding favourites for Z-Wave :
1. Open the Configuration interface.
2. Go to
>
Devices.
3. Open the device properties and select Advanced.
4. To start the process, click Configure.
5. The controls for configuration (up, down, stop) will appear.
