- 29 -
Unidentified
Type of Fibers
Shock occurred to the splicer
during the splicing process
Execute “Motor Clibration”
If the [problem still exist, please
contact the sale agent
Contact of Fiber
End-faces
Overlap too much
Adjust overlap parameter
Motor is not calibrated
Calibrate and maintain the motor
Focus Motor
Overrun
The fiber is misplaced
Press the “Reset” vutton and then
reposition the fiber correctly
There’s dust of dirt on the fiber
surface
Prepare the fiber again
There’s dust of dirt on the fiber
surface
Execute the [Dust check] after the
lenses and LEDs are cleaned
Fibers
Mismatch
The fibers of two sides are
different type
It may resul tin large splice loss if
you continue to splice,
Please use the proper splice mode
corresponding to the fibers
Large Cleave
Angle
Bad fiber end-face
check the condition of the fiber
cleaver, if the blade is worn,
rotate the blade to a new position
or change a new one, and then
re-prepare the fibers
[Cleave Limit] is set too low
Increase the [Cleave limit] to an
adequate limit(standard:3.0˚c)
Large Core
Angle
[Core angle limit] is set too low
Increase the [Core angle limit] to
an adequate limit (standard:1.0˚c)
Dust of dirt is on the V-groove or
hte clamp chip
Clean V-groove and clamp chip.
Prepare the fibers and re-load
them
Focus Error
Too large axial offset(>0.4um)w
Re-prepare the fibers
The motor is not calibrated
Execute [Motor clibration]
Summary of Contents for Mini5C
Page 25: ... 25 ...
Page 33: ... 33 ...
