I
Operation Safety Rules
High optical power can cause bodily harm, especially to eyes.
Never look directly into the end of the optical transmitter fiber
jumper or the end of its active connector.
Exercise care if you must bend fibers. If bends are necessary,
the fiber bending radius should never be less than 38mm.
Power socket overload, broken cables or broken plugs may
cause electric shock or fire. Regular check-ups on power supply
wires and cables are essential. If any appears damaged, replace
at once.
Use the power supply adapter provided in the package only.
Using other adapters may cause equipment damage or
operation failures.
Install the equipment in a well ventilated environment without
high temperatures or direct sunlight to protect the equipment
and its components from overheating, which can result in
damage.
Avoid moisture, dampness and water damage. Equipment
exposed to water cannot work normally and can be extremely
hazardous due to shorting.
Do not lay this equipment on an unsteady base.
