2
AT command
control
The module uses software to control the flight mode by
default. When AT+GTFMODE=0:
run the AT+CFUN=0 command to enter flight mode.
run the AT+CFUN=1 command to enter normal mode.
5.9. Sleep/Wakeup Interface
When the module is in sleep mode, the module can be awakened by pulling down
WAKEUP_IN pin.
Table 25. Sleep/wakeup interface
Pin Name
I/O Pin Number Description
WAKEUP_IN DI
38
External device wake-up module, active low by default
The module supports setting wake-up mode and waking up active level through AT
commands. For details of configuration method, see
Fibocom_FM101-NA_AT Commands User Manual
.
5. Functional Interface
Copyright © Fibocom Wireless Inc.
43
Fibocom Confidential
